pokémon

Attempt #2 

Forgot to save the last project (lost file) sooo..... decided to make it even bigger. This one should be two and a half feet tall. 

It is Umbreon by the way. Going to be a 8 - 10 print depending on how many mistakes happen.

Legs should be done in the morning 🤞🏾

This is the 2nd attempt printing them, 1st attempt was a failure. One of the legs fell over and created a spaghetti mess 😭

Also ran out of black filament so using what I got for the rest of the print

What is your infill on these parts?  
You really don’t need much at all for stuff like this

I am a maker. I communicate through photos. Also do metal casting, 3d prints,
AI, robotics and mashups of all of these things.
http://tmophoto.com


Started at 50% then went to 40% I’m gonna have to change again. Going to try 30%. What do you recommend?

15 or less is more than enough, you could probably get away with much less than that.  Try a single part at 5-7% see if it works and increase the outer shell by one (sometimes with low infill the infill is visible on the outside surface and doesnt look good).  25% or so is really strong for functional parts like brackets etc. 

print time will drastically reduce and you will use way way less plastic.

Its so much fun, if you ever have any questions let me know. been running printers since about 2010

Oh wow, my way to dense than. I just accepted that this was supposed to be more than 25% but I see what you’re saying. It’s heavy and thick. That’s what my problem was for one of the legs when printing. It keep getting top heavy and would fall over. Thanks for the recommendation/advice. This is my 6th ever print. First more than 24 hr print