pokémon

Attempt #2 

Forgot to save the last project (lost file) sooo..... decided to make it even bigger. This one should be two and a half feet tall. 

It is Umbreon by the way. Going to be a 8 - 10 print depending on how many mistakes happen.

Legs should be done in the morning 🤞🏾

This is the 2nd attempt printing them, 1st attempt was a failure. One of the legs fell over and created a spaghetti mess 😭

Also ran out of black filament so using what I got for the rest of the print

What is your infill on these parts?  
You really don’t need much at all for stuff like this

I am a maker. I communicate through photos. Also do metal casting, 3d prints,
AI, robotics and mashups of all of these things.
http://tmophoto.com


15 or less is more than enough, you could probably get away with much less than that.  Try a single part at 5-7% see if it works and increase the outer shell by one (sometimes with low infill the infill is visible on the outside surface and doesnt look good).  25% or so is really strong for functional parts like brackets etc. 

print time will drastically reduce and you will use way way less plastic.

Started at 50% then went to 40% I’m gonna have to change again. Going to try 30%. What do you recommend?