Content
@
https://warpcast.com/~/channel/cal
0 reply
0 recast
0 reaction
Callum Wanderloots ✨
@wanderloots.eth
After a few months away from writing, I'm back on @paragraph ! I hope this gives you a bit of a glimpse into what I've been up to and where my head is at ✨ I would love to hear what you think 😊 https://paragraph.com/@wanderloots.eth/56-reflections-on-10000-youtube-subscribers?referrer=0x316822580ee3725209fD96b1208ef53b73825E56
6 replies
1 recast
8 reactions
Callum Wanderloots ✨
@wanderloots.eth
hmm @reidtandy or @colin where did the canonical URL setting go? I couldn't find it for this one
1 reply
0 recast
0 reaction
Reid DeRamus
@reidtandy
From the dashboard, if you choose to "Import post" below "New post", you should see the option to set the canonical URL.
1 reply
0 recast
1 reaction
Callum Wanderloots ✨
@wanderloots.eth
Ohh I see, I just copy and pasted it from my blog, since the import usually distorts the formatting. Does that mean there’s no way to set the canonical url after publishing a post, if it was not imported?
1 reply
0 recast
1 reaction
Reid DeRamus
@reidtandy
Ahh yes, sorry, you can do so from the publish screen (after you press "Continue" from the Editor, under "Advanced settings".
1 reply
0 recast
1 reaction
Callum Wanderloots ✨
@wanderloots.eth
Got it! So you have to go through the whole “publishing” flow again, it can’t just be updated from the normal post settings section Is that because arweave needs to be updated? As one note, I’m always slightly concerned I’m going to accidentally email everyone again after I hit continue and change those settings haha
1 reply
0 recast
1 reaction
