vrypan |--o--|
@vrypan.eth
If you have installed Hubble from scratch in the last 2 weeks, can you please comment here? (No upgrade, a new, clean install). I have been trying for two weeks and something is not working for me. I need to understand if this is on my side or something else. 🙏
1 reply
0 recast
2 reactions
Harris
@harris-
Same here @vrypan.eth Went so far as to change my internet provider and IPs, installing a new hard drive and nuking everything a few times, trying different command line arguments to not sync from snapshot (seems to not be used in the hubble,sh script) and installing docker several times through different methods (snap, apt) Never finishing the first sync according to the dashboard, though it looks like it receives gossip from a bootstrap node (before disconnecting from it every few days from it until I restart) and it can discover peers, just never connects to them or allows inbound connects, I can only assume because it never considers itself as having "initially synced" just from a cursory glance at the hubble codebase but I can't really be bothered to spend much more time reading through the code, maybe I'll try again once snapchain is closer to release
3 replies
0 recast
1 reaction
Sanjay
@sanjay
Hmm, this is odd that the messages are increasing so fast but peers are 0. Wonder if it's more of a metrics reporting issue than the fact that there are no peers. Could you DM me the most recent logs from the hub?
1 reply
0 recast
0 reaction
Harris
@harris-
The peers were zero because the bootstrap peer gets dropped every now and then after a few hours, I think the messages are increasing because it's still processing blocks and pending sync messages from when it was connected. Finally figured out how to set the hub options correctly so I'm just syncing from fresh without a snapshot again. I also don't know how to get logs I couldn't find the config or where they're being written to in the code
1 reply
0 recast
0 reaction
